Quick AttachTM Fittings are precision machined from 316 stainless steel and Lloyds approved
under #97/00200 for holding power of at least 90% of the maximum breakload of the wire
rope used. Special attention has been placed on the strength of the terminals, which guarantees
that the wire will always break before the fitting even gets distorted.
The advantage of “Quick AttachTM” over conventional fittings is the arrangement of the wedges
on the outside of the cable which makes assembly much easier and allows different types
of wire to be used with the same fitting.
Quick AttachTM fittings are ideal for repair of rigging without swaging and for many other
industrial, or architectural uses where the exact length of the cable cannot be determined
beforehand or where assembly needs to take place on-site.
3 Easy Steps
1. Unscrew and verify components.
2. Place cable through
end fitting. Insert
cable 1/4” to 3/8”
through cone fitting.
Place washer over
cable and assemble.
3. Tighten lock screw.
You’re done! |
